You might search for Star Wars balloon animals. Here is the guide.
Guide to Make Star Wars Balloon Animals
STEP 1
Star Wars Balloon Animals – The tip of your sword is going to be the first point of debate between us. Using jewel tones in the blade’s design, which I believe lends the weapon an air of authenticity, is something that I take great pleasure in accomplishing. Nonetheless, the use of ordinary colors in their stead works appropriately and effectively as well. I’m going to refer to it as normal for the sake of this lecture.
When you have inflated one 260 to its full potential, give it a brief squeak to ensure that the balloon still has some give to it.
STEP 2
Star Wars Balloon Animals – You should first determine how long you want your blade to be, then press the end of the nozzle to expel any air that may be trapped inside, and then, measure the length of your blade. You can make sure that the cutting edge of your lightsaber will have an attractively rounded tip if you use the second half of the balloon.
This will allow you to cut more efficiently. In a typical scenario, I will exhale around one third of the air that I am holding in. Make sure to leave a sufficient amount of excess length so that you will be able to do two pinch twists at the bottom of the necklace. When you have finished with this procedure, you should remove any excess.
STEP 3
Create your own blade by giving it two pinch twists at the very bottom of the blade.
STEP 4
Star Wars Balloon Animals – Once the second 260 has been inflated to around half of its capacity, tie a knot in the end of it. You will only need a little piece of this balloon in order to create the hilt of your sword, which can be found here. It is essential to give the balloon a squeak in order to ensure that it will have some degree of flexibility.
STEP 5
Build two pinch twists that are exactly the same size as the ones that are already on the blade.
STEP 6
When you have brought the two pinch twists from the hilt into proximity with the two pinch twists from the blade, you may proceed to twist the four pinch twists together in a direction that is perpendicular to the blade.
STEP 7
Star Wars Balloon Animals – Place one hand on either side of the pinch twists, and then use the other hand to give them an additional twist by doing a vertical twist. Position the pinch twists so that they are standing vertically, and then arrange them so that the colors alternate and the hilt and blade are on opposite ends of the pinch twists. The blade is given its strength by this cluster of four pinch twists, which also keeps it from being as unstable as some of the other blade designs that are comparable to those that I have seen.
STEP 8
Alternatively you may add extra complexity to your design by forming two pinch twists at the base of the hilt (this is a required step if you want to make Darth Maul’s double-bladed lightsaber). If you are short on time, you may just measure out how long you want the hilt to be and then knot it off at that length. When you have completed cutting off the excess and tying it off, you are finished!
STEP 9
In order to give a little bit more complexity to the artwork, I usually draw a power button and a few little markings to the hilt of the weapon. That brings us to the end! To put it more succinctly, that sums up all there is to know about it!
Related to Star Wars Balloon Animals – how to make balloon animals toy